If this is new, think you have a wheel adjusted too tight. When this happens, during rest it develops a small flat spot which translates to mechanical ringing in the print. If you let the machine sit for a while, then slowly move that axis, do you feel a bump where it was at rest? All of the axes should be smooth with no felt noise. If you feel noise, you’ll see it in prints.

If not, I would inspect your axis rails for any contaminants or damage, I used one of my printers so much I wore out the actual aluminum extrusion on the y axis and the bed was developing mechanical slop, which was actually difficult to find until I checked the bearing races.

What a gorgeous feline!

There was also DIGG. There were several large aggregators, but they all made changes that lead to mass exoduses to reddit. Back in the day there were sites like SomethingAwful, EBaumsWorld that served up memes and entertainment before we had purpose-built aggregation tools. Eventually reddit will make way for something else (and already has to some degree with its shedding of users to Lemmy).

PETG is food safe. However! Because FDM is full of gaps, cracks, and voids, NEVER use it to store food that can spoil. Food bits can get trapped in these voids and present a persistent risk for foodbourne illness.

Granulated sugar would be fine if it’s kept very dry, however do note that said voids will not make an airtight container. So I wouldn’t even use it for stuff affected by humidity or oxygen.

If anything I’d almost suggest clearing the inside with a food safe platinum silicone, which should solve most of these issues.